Do You Have an Inefficient Furnace in Yuma, AZ?

At some point, the furnace in your home will most likely lose efficiency or malfunction. Parts wear out and need replacing, but you’ll usually notice signals to take such steps. Here are a few signs that your furnace is not performing at peak efficiency in your Yuma, AZ home.

Extremely Long Cycles

A heating cycle longer than 10 to 15 minutes may be cause for concern unless you’re starting with a close-to-freezing indoor temperature. The reasons could range from a faulty limit switch to a weakening blower motor. Maintenance can often prevent such issues if performed at least once a year.

Short-Cycling Furnace

Perhaps your furnace shuts down before reaching your set temperature point. Assuming that you’re changing your air filter regularly and having your thermostat calibrated annually to ensure accurate temperature readings, the cause could lie in dirt and dust build-up within the furnace. Such build-up creates an insulating layer on the motor and heat exchanger, overheating them and forcing the furnace to shut down for safety reasons.

Low Air Pressure

Put your hand to the supply vents while the furnace runs. If the air isn’t blowing out as strongly as you’re used to, there’s probably an issue with the blower motor.

Another possibility is that the ducts have become clogged. Low air pressure usually goes hand in hand with cold spots in the rooms farthest from the air handler.

A Higher Utility Bill

Unless you’re running your furnace longer than normal, you shouldn’t see much variation in your monthly energy bill. A higher bill, especially when combined with one of the above issues, tells you your furnace needs an inspection.

Our company has provided quality service for over six decades, and our NATE-certified technicians are available 24/7. For a heating service that will boost your furnace’s efficiency, call Quick Refrigeration in Yuma, AZ.

Image provided by iStock